Whatever the water treatment used, automatic or manual, pH Perfect is essential for your comfort.
+ Clear, soft, problem-free water
+ Does not burn your eyes

 

+ Self-regulating treatment
+ Easy to set
+ Regulator safety system
    + No possibility of overdosage
    + Anti-odour pipe
    + Alarm to signal insufficient corrector liquid

 

In this way, the balance of the water in your pool is kept at the desired value without any intervention by you.

 

For your comfort:

 

+ For the comfort of bathers, the pH in the pool must be maintained between 7.2 and 7.4.
+ Below this, the water is harsh. Above this, bigger doses of disinfectant are needed to keep the water healthy and combat the development of algae.

+ More about the pH:
    + The pH is the measure of the hydrogen potential (concentration of H+ ions) in the water.
    Its value is between 0 and 14; - 0 being very acidic, 7 neutral and 14 very alkaline.
    + The mineralogical quality of the water, the climate, the addition of water,and the number of bathers, all result in the pH varying continually and naturally.

pH Perfect regulates the pH in all pools

Automatically adapts itself to the situation

pH Perfect integrates the technology of proportional dosing to automatically maintain an ideal pH for the comfort of bathers.
+ Thanks to its microprocessor, pH Perfect effectively corrects the pH in your pool by optimizing the injection of corrector.
+ pH Perfect measures the pH value using a pH sensor located on the filtration circuit, which continuously analyzes the pool water.
+ Depending on the reading, pH Perfect adjusts the pH in your pool upwards or downwards with its dosing pump by adding corrector liquid.
The dosing time depends on the difference between the pH in your pool and the ideal pH.

A few tips

+ pH Perfect combines with all types of water treatment whether manual or automatic.
+ pH Perfect is suitable for all types of surfaces, and can be installed on both existing or new builds.

 

Technical specifications
Electricity supply 50 HZ	220-240 V AC
Consumption	9 W
Primary safety	500 mA T
Maximum flow in the peristaltic pump	1.5 l/h
Maximum backpressure (injection point)	1.5 bar
Connector collar	on pipe DN 50 (origin) & DN 63
pH check range	0.0 pH - 14.0 pH
Measurement accuracy	+/- 0.1 pH
Type of sensor	combined, simple joint, Kcl, polymer gel, epoxy body Ø12 mm
Semi-automatic calibration of the sensor	with buffer solutions (1 or 2 steps)
pH sensor tolerance	6 bar / 60°C
Protection factor	IP65
Dimensions (L x W x H)	235 x 200 x 85 mm
Total weight	1.7 kg (approximately)